precipitation annealing
英 [prɪˌsɪpɪˈteɪʃn əˈniːlɪŋ]
美 [prɪˌsɪpɪˈteɪʃn əˈniːlɪŋ]
网络 析出退火
双语例句
- Analysis on the microstructure shows that precipitation of compound containing titanium was found in the steel, and its amount increases with the elevation of annealing temperature.
显微组织分析表明，含钛钢中生成了钛化物相，并且随着退火温度的提高，钛化物析出量增多。 - The factors of recovery, recrystallization, precipitation of secondary particles, dissolution of the solute atoms, etc. in the fibrous structure during isothermal annealing processes can be used to explain the changes of microstructure and properties of the alloy.
可以用纤维组织的回复、再结晶、次生相析出及溶质原子溶解等因素在等温退火过程中的变化来分析材料组织、性能的变化。 - The precipitation behavior of AA 3003 aluminum alloy during annealing as well as its effect on the microstructures of alloys was investigated by means of hardness, electrical resistivity measurements, optical microscopy and transmission electric microscopy.
通过硬度、电阻检测以及光学显微镜、透射电镜观察，研究了AA3003铝合金在退火过程中的析出行为以及对合金显微组织的影响。 - Precipitation Characteristics of Al-Mg-Mn-Sc-Zr As-Cast Alloy during Homogenization Annealing
铝镁钪合金铸锭均匀化过程中的析出特性 - Precipitation and recrystallization of AA 3003 aluminium alloy during annealing
退火过程中AA3003铝合金的析出与再结晶 - It is found that RTP is a rapid and effective way to dissolve oxygen precipitation in comparison with conventional furnace annealing.
实验发现，RTP是一种快速消融氧沉淀的有效方式，比常规炉退火消融氧沉淀更加显著。 - After annealing under different conditions, the variation of oxygen precipitation and the bulk microdefects ( BMDs) density with annealing time at high temperatures was measured, and transmission electronic microscope was used to observe the microstructure of oxygen precipitates.
通过不同温度高温退火后，测量氧沉淀的生成量和观察硅片体内微缺陷（BMD）密度与高温形核时间的变化关系，同时用透射电子显微镜（TEM）观察氧沉淀及相关缺陷的微观结构。 - Effect of nitrogen on oxygen precipitation in Czochralski silicon during high-temperature annealing
直拉硅中氮在高温退火过程中对氧沉淀的影响 - The experimental results showed that high density of oxygen precipitation and induced-defects were formed after annealing of wafers at moderate and high temperatures.
重掺砷硅单晶在中高温退火时形成密度较高的氧沉淀及诱生缺陷。 - Al-Ti composite oxide films were achieved by hydrolysis precipitation and anodizing. The influence of technological parameters, including concentration, temperature and pH of solution containing Ti4+ ions, impregnating time and annealing time on the specific capacitance of Al-Ti composite oxide films were studied.
用水解沉积-阳极氧化法制备高介电常数的Al-Ti复合氧化膜，研究了含钛无机盐溶液的浓度、温度、pH值处理时间，以及退火温度对Al-Ti复合氧化膜比容增长率的影响。 - For the powders milled for 60 h, besides the relaxation of crystal defaults and lattice stress, the crystallization of amorphous and the precipitation of NiW phase were both evident during the annealing.
球磨60h粉末在退火过程中除了晶体缺陷和应力释放等过程以外，有明显的非晶晶化和NiW相析出过程。